A parking barrier gate system controls the vehicle entrance and exit points of a site: parking lots, residential compounds, commercial buildings, and factories. Instead of a single product, a complete system combines boom barrier gates at the lane, optional per-bay parking locks, and access-control integration for authorized vehicles. Anxia manufactures and exports these components from Shenzhen, covering both the lane-level parking barrier gate and the devices that manage individual bays. This page indexes the main options, the measured specifications behind them, and the selection factors that determine which parking barrier gate configuration suits a given entrance.
Boom barrier gates handle the main traffic lane. The DC series uses a DC 24 V motor with 3-6 s open/close times, a mechanism life of ≥5 million cycles, a 304 stainless steel cabinet, an operating range of -40°C to +70°C, and a 1-6 m arm. The brushless DC660Y-L/M/R series offers open times of 5.5 / 3.5 / 2 s, 45-110 N.M torque, a 330 W motor, and arms of 4–6 m (L), 3–5 m (M), or 3–4 m (R).
Remote control parking locks control an individual bay rather than a lane. Rise and lower times are ≤6 s, with 420 mm raised height and 75 mm lowered height. Remote range is ≥15 m over RF 433 MHz, operating temperature is -10°C to +55°C, and power is DC 6 V. The unit measures 460x460x90 mm and weighs 10 kg. Patent ZL 201120188300.9 (as stated on the product page).
License plate recognition is a solution capability that Anxia integrates at project level with boom barrier gates and access-control components, rather than a fixed catalogue item. It allows the barrier to open for registered vehicles without a card or fob. Integration is specified per project alongside the barrier model and lane layout. We do not publish specific LPR models on this page because configuration is defined during project engineering.
Four variables drive the specification. Entrance width determines arm length (1-6 m) and whether a single or dual barrier is needed. Traffic volume determines open time: a 2 s brushless barrier suits high-frequency lanes, while a 5.5 s opening is adequate for lower-volume sites. Operating environment matters: the DC series is rated -40°C to +70°C, while the brushless DC660Y series is rated -20°C to +50°C — match the model to the site. Finally, decide whether control is required at the lane only or at each bay, which determines whether parking locks are added alongside the barrier gate.
How do I choose the arm length?
Match the arm to the clear entrance width. Arms are available from 1-6 m; a wider lane requires a longer arm and correspondingly higher torque, as in the DC660Y series at 45-110 N.M.
What is the difference between a brushless and a standard DC motor barrier?
Open times differ. The brushless DC660Y-L/M/R opens in 5.5 / 3.5 / 2 s with 45-110 N.M torque and a 330 W motor. The standard DC boom barrier gate opens in 3-6 s with a ≥5 million cycle mechanism life.
Is the equipment suitable for outdoor use?
The DC series cabinet is 304 stainless steel, rated -40°C to +70°C. The brushless DC660Y series is rated -20°C to +50°C. Parking locks are rated -10°C to +55°C, so they suit covered or moderate outdoor bays rather than extreme-cold installations.
Send us your entrance width, expected traffic volume, and required arm length for a barrier gate specification.
Contact our team to discuss your parking entrance project.
Tell us the entrance width, vehicle flow, and arm length requirements.
Discuss Your Parking Entrance Project